I recently began construction of the rotary table kit supplied by Promica. It went reasonably smoothly, I was able to work around most of the issues that popped up, making a few mods here and there. Have a look at the photos!
Rotary table construction
- 0
- September 14, 2010
Hello,
Just wondering how the conversion kit is held to the Vertex. I recently purchased a vertex and am looking to do this conversion.
Brad.
Hi Brad,
From memory the Promica TV6 kit is held on by 4 x M5 machine screws into the cast iron block. It’s pretty solid, the only minor problem with the unit is the small amount of backlash inherent in the worm drive (pretty much unavoidable in this budget range though!)